I have just finished a prototype of one of my first kits for our entry into the N Scale Laser Cut Kitting company world. Have a look at these teasers of Seabiscuits Boatworks. We hope to have everything up and running on the Web for a March launch.
We have been busy putting some kits together, designing some new ones and getting the website up and going along with a good E-commerce system. Had to make a few changes with the e-commerce side as the initial one we chose was a bit too clunky for my liking. Here are a few more teasers of some kits to come. Once we have the site up and running I will ask to get a thread going here in the partner section. Should only be another week or so, .... I hope!!
Well, it came out a bit more extravagant than we initially planned due to all the cutting and engraving required, but it is a pretty detailed kit with lots of parts and character. This will be a great building as a boat manufacturer/repair company, fish market or even a ferry terminal. We might be doing up a matching water taxi service as well to attach as a lower dock. • 6 sheets of laser cut and engraved stabilized Resin Impregnated Board (RIB) for crisp, high resolution detail (same as Laser board) • 2 Seabiscuit 18’ boat kits • Gantry boat hoist • boat dolly • shed clutter parts for boat fabrication (RIB) • laser cut clear window glazing • lots of extra bracing material • Styrene strip and shapes • 1/12” dowel material for pilings • printed signage sheet • 16+ pages of detailed instructions which will be avialable via PDF.